C1: Motional Capacitance
L1: Motional Inductance
R1: Motional resistance
Co: shunt Capacitance.
The oscillator designer treats the crystal unit as a circuit component and just deals with the crystal unit’s equivalent circuit. Shown above is a simple equivalent circuit of a single-mode quartz resonator. A resonator is a mechanically vibrating system that is linked via the piezoelectric effect, to the electrical world. Below is the explanation of Parameters.
Motional resistance R1:
This is a resistance in the series arm of the equivalent circuit when the conductance becomes maximize in an admittance diagram. This is a loss resistance when the crystal unit is vibrating and, the smaller this value, the better the crystal unit.
Motional Inductance L1:
If the value is larger, Q becomes higher and the oscillation stability increases.
Motional capacitance C1:
The larger this value, the greater frequency variation for a change of load capacitance. Therefore C1 must be kept as small as possible for high stability oscillators. VCXO must have a somewhat larger C1 to allow a large frequency shift. Changing these value to control C1 will cause such problems as Discontinuous Frequency Temperature characteristics. Generally in case of a smaller crystal unit, C1 becomes small and inversely proportional to L1.
Shunt capacitance Co:
This is the capacitance between electrode films and is determined in accordance with the thickness and the area of electrodes.
Series resonance frequency fs:
Frequency calculated from the equivalent constant, L1,C1.
Parallel resonance frequency fp:Frequency calculated from the equivalent constant,
|6||What is a VCXO||Frank||2019-07-09||2813|
|5||Specify a Crystal||Frank||2019-07-09||1446|
|4||Negative Resistance Measurement||Frank||2019-07-09||1391|
|2||Oscillation Condition and Negative re...||Frank||2019-07-09||1512|